smartpro 230v 3kva 2.25kw line-interactive ups, extended run, snmp, webcard, tower, usb, db9 serial model number: SMARTINT3000VS description tripp lite's SMARTINT3000VS intelligent, line-interactive tower uninterruptible power supply (ups) prevents data loss, downtime and equipment damage due to power outages, voltage fluctuations and transient surges. large internal batteries offer 14 minutes half load runtime and 4 minutes at full load. runtime is expandable with optional external battery packs. maintains regulated 230v nominal output without using battery power during brownouts and overvoltages from 151 to 282v. 3000va power handling capability offers compatibility with a variety of networking, telecom and other sensitive electronic applications. includes a total of 9 outlets with 3 load banks that are individually switchable via software interface to reboot select equipment on demand or shed less significant loads to extend battery runtime for more critical equipment. supports simultaneous remote monitoring of ups and site power conditions via built-in usb and db9 monitoring ports. includes poweralert ups monitoring and unattended shutdown software with complete cabling. built-in accessory slot supports snmp with optional snmpwebcard adapter. emergency power off (epo) interface offers option for instantaneous power-off of ups and connected equipment in the case of fire or emergency. multi-function audible alarms and set of 5 front panel leds offer at-a-glance notification of ups and line power status. network-grade ac surge suppression protects equipment from damage and performance problems resulting from transient surges and line noise. attractive gray color scheme. features SMARTINT3000VS line-interactive ups offers protection from blackouts, brownouts, overvoltages and surges 3000va / 2250 watt capacity internal batteries support a half load of 1500va for 14 minutes and a full load of 3000va for 4 minutes runtime is further expandable with the addition of bp48v24-2u (limit 1), bp48v60rt-3u (multi-pack compatible) and bp48v27-2us (multi-pack compatible) external battery packs maintains regulated 230v nominal output during brownouts and overvoltages from 151 to 282v includes 9 ups supported outlets with 3 individually controllable load banks (2 outlets per bank) that can be powered off and back on again via software interface iec320-c20 input connection accepts a variety of detachable cord sets to match country or site-specific wall receptacles poweralert ups monitoring and unattended shutdown software included offers simultaneous monitoring by up to 4 directly-connected devices through included usb and db9 interface ports, or the monitoring by any number of highlights 3kva / 3000va / 2250w line interactive tower ups system 230v nominal output during brownouts to 151v and overvoltages to 282v extended runtime options, front panel status leds usb, rs232, epo and optional snmp/web interface; 3 switched load banks c20 inlet; 8 c13 & 1 c19 outlets; 3 c13 to c14 cables included package includes SMARTINT3000VS ups system poweralert software with usb and db9 cables cable for emergency power off interface instruction manual with warranty information c13 to c14 power cables (3) 1 / 5
additional servers over ip with included poweralert monitoring software communications ports support messaging of ups and line power status, including on-battery, low-battery, power restored, ac line voltage, dc battery voltage and remaining battery capacity emergency power off (epo) interface with cable supports timed inverter shutoff after unattended shutdown, activate self-test and ups output power control for delayed or immediate reboot of connected devices optional pdubhv20 bypass pdu enables hot-swappable ups replacement with no disruption to connected equipment supports tripp lite's watchdog software application (requires optional watchdogsw) built-in accessory slot supports snmp with optional snmpwebcard adapter emergency power off (epo) interface with cable multi-function audible alarms and set of 5 front panel leds network-grade ac surge suppression specifications output output capacity details 2250w maximum with up to 1 external battery pack; 1500w maximum with 2 or more external battery packs output volt amp capacity (va) 3000 output kva capacity (kva) 3 output watt capacity (watts) 2250 output kw capacity (kw) 2.25 power factor 0.75 nominal output voltage(s) supported 220v; 230v; 240v nominal voltage details 230v nominal inverter output voltage frequency compatibility 50 / 60 hz output voltage regulation (line mode) -19% +8% output voltage regulation (battery mode) +/- 5% output receptacles (8) c13; (1) c19 included output power cables includes 3 c13 to c14 output power cables load management receptacles three switchable two-outlet c13 load banks output circuit breakers 10a (x2) - each breaker protects 4 c13 outlets each, c19 is unbreakered output ac waveform (ac mode) sine wave output ac waveform (battery mode) pwm sine wave input rated input current (maximum load) 15.4a 2 / 5
nominal input voltage(s) supported 230v ac ups input connection type c20 inlet ups input connection description user supplies input cabling with c19 output connection input phase single-phase battery full load runtime (min.) 4 min. (2250w) half load runtime (min.) 14 min. (1125w) expandable battery runtime extended runtime supported via optional external battery packs external battery pack compatibility bp48v24-2u (limit 1); bp48v60rt-3u (multi-pack compatible); bp48v27-2us (multi-pack compatible) dc system voltage (vdc) 48 battery recharge rate (included batteries) less than 4 hours from 10% to 90% (typical, full load discharge) internal ups replacement battery cartridge rbc54 battery access battery access door battery replacement description hot-swappable, user replaceable batteries voltage regulation voltage regulation description automatic voltage regulation (avr) maintains line power operation with an input voltage range of 151v to 282v overvoltage correction input voltages between 245 and 282 are reduced by 12% undervoltage correction input voltages between 177 and 199 are boosted by 14% severe undervoltage correction input voltages between 151 and 176 are boosted by 30% user interface, alerts & controls switches 2 switches control off/on power status and alarm-cancel/self-test operation alarm cancel operation power-fail alarm can be silenced using alarm-cancel switch; once silenced, alarm will re-sound to indicate low-battery status audible alarm audible alarm indicates power-failure, overload and low-battery conditions led indicators 5 leds indicate line power, battery power, overload, voltage regulation and battery low/replace status surge / noise suppression ups ac suppression joule rating 480 ups ac suppression response time instantaneous emi / rfi ac noise suppression yes physical 3 / 5
primary form factor tower ups power module dimensions (hwd, in.) 14.2 x 9.2 x 12 ups power module dimensions (hwd, cm) 36.2 x 23.5 x 30.5 ups power module weight (lbs.) 61 ups power module weight (kg) 27.7 ups shipping dimensions (hwd / in.) 16 x 14.8 x 19.8 ups shipping dimensions (hwd / cm) 40.6 x 37.5 x 50.2 shipping weight (lbs.) 67.5 shipping weight (kg) 30.6 cooling method fan ups housing material polycarbonate environmental operating temperature range +32 to +104 degrees fahrenheit / 0 to +40 degrees celsius storage temperature range +5 to +122 degrees fahrenheit / -15 to +50 degrees celsius relative humidity 0 to 95%, non-condensing ac mode btu / hr. (full load) 488.3 ac mode efficiency rating (100% load) 94% audible noise audible noise < 47dba at front side 1 meter communications communications interface usb; db9 serial; epo (emergency power off); slot for snmp/web interface network monitoring port description supports detailed monitoring of ups and site power conditions poweralert software included communications cable 2 usb and 2 db9 cables included watchdog compatibility supports watchdog application, os and hard-reboot restart options for remote applications line / battery transfer transfer time 2-4 milliseconds low voltage transfer to battery power (setpoint) 151 high voltage transfer to battery power (setpoint) 282 special features 4 / 5
cold start (startup in battery mode during a power failure) cold-start operation supported high availability ups features hot swappable batteries green energy-saving features individually controllable load banks certifications ups certifications ce ups certification details ce 62040 warranty product warranty period (international) 2-year limited warranty product warranty period (mexico) 2-year limited warranty product warranty period (puerto rico) 2-year limited warranty ? 2015 tripp lite. all rights reserved. all trademarks are the sole property of their respective owners. tripp lite has a policy of continuous improvement. specifications are subject to change without notice. photos may differ slightly from final products. 5 / 5
|
